Queclink GMT100 Especificações descarregar pdf (Página 63)

GMT00 @Track Air Interface Protocol

TRACGMT100AN001 – 62 –

3.3. Report

This section defines the formats of the report messages. Due to the max length of SMS message

(160 bytes), it is recommended to carefully set the <Report Composition Mask> in AT+GTCFG

to limit the length of the report which contains GPS position information if you choose SMS as

the transmit method. Otherwise the report will be truncated to fit the length of SMS message.

3.3.1. Position Related Report

 +RESP:GTTOW,

If the tow alarm is enabled by the command AT+GTTOW, the device will send the message

+RESP:GTTOW to the backend server when the motion sensor detects tow.

 +RESP:GTDIS,

If the status of digital inputs are detected being changed, the device will send the message

+RESP:GTDIS to the backend server.

 +RESP:GTIOB,

If the IO combination is set and the corresponding condition appears, the device will report the

message +RESP:GTIOB to the backend server.

 +RESP:GTGEO,

If Geo-Fence is configured and enabled, the device will send the message +RESP:GTGEO to

the backend server according to settings when the device enters or exits the Geo-Fence.

 +RESP:GTSPD,

If the speed alarm is enabled, the device will send the message +RESP:GTSPD to the backend

server when the speed of the device is detected into the alarm range,.

 +RESP:GTSOS,

If the SOS mode is set to 1, the device will send the message +RESP:GTSOS to the backend

server when the corresponding digital input port triggers SOS.

 +RESP:GTRTL,

After the device receives the command AT+GTRTO, it will start GPS to get the current position

and then send the message +RESP:GTRTL to the backend server.

 +RESP:GTDOG,

The protocol watchdog reboot message.

 +RESP:GTIGL,

The protocol ignition on location message.

Queclink

Confidential

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 110 111

Sem comentários

Queclink GMT100 Especificações Página 63